DriverGuide
English Português Español Deutsch Français 中国 Italiano 日本語 Translate
  


DriverGuide Forums



Go Back   Free Drivers Download | Request and Support Forums > Computer Hardware Forums > Controllers (IDE, SCSI, IEEE1394, ...)

  #1  
Old 03-31-2008
welsh1955 welsh1955 is offline
Junior Member
 
Join Date: Mar 2008
Posts: 1
welsh1955 is on a distinguished road
Question DiamondMax Plus 8

I have taken a working 20 gig IDE out of a Gateway E-1400 tower and wanted to replace it with a Maxtor DiamondMax Plus 8 40 gig,,It shows in set up as N40P and when I go to install Windows XP Professional,,,It says it cannot find hard drive,,I have switched jumpers from master to cable select and no difference,,Am I doing something wrong,missing something somewhere,,I heard I should use a ata cable instead of an IDE cable,,Any suggestions,
Thanks,
Ray
Reply With Quote
Sponsored Links
    
  #2  
Old 03-31-2008
Jerry K's Avatar
Jerry K Jerry K is offline
Super Moderator
 
Join Date: Sep 2003
Posts: 37,070
Jerry K is on a distinguished road
Default Re: DiamondMax Plus 8

Yes, this drive requires an ATA/133 controller. You didn't mention what controller you have it connected to so I can only assume your present controller isn't ATA/133.

You should jumper it the same as the original drive. Also, the use of an 80-wire cable is suggested because of the high speed at which it must operate.
Reply With Quote
Reply [Upload Driver/Firmware]



Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT. The time now is 11:16 AM.



2017 DriverGuide is an iCentric Corporation Company.     All rights reserved.    


Powered by vBulletin Version 3.0.1
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.