HI,
1.Got bios from shuttle...for bigger drive ..followed instructions. using 631wiq03.exe from shuttle.
2.Floppy kept churning but after 10 minutes still going
3.Instructions said dont shut off ...but what could I do..
4. Shut unit off and now no video...if i put boot disk
and do dir its alive but the video screen is blank.
5. TRied a second monitor but same.
6. What can I do to unhose my video ?
7. Could it be a bad video card all of a sudden ?

All is not lost! Several questons come to mind? Are you useing the the AGP slot on your board? Do you have a vga card for a PCI slot? If you have a vga card for a PCI slot, take the card out of the AGP slot! Take the old vga card and place it in the PCI slot! Since on boot up you still have the floppy being recognized you can still flash the bios back as it was before the bad flash! If you saved the old bios! The board you have has the award bios! Did you save the old bios?
To recover BIOS:
Go here and download
http://www.drd.dyndns.org/howto/BIOS-Recovery.pdf
Depending on how well you like your old board and want to keep it!
Options: Get a new bios chip! Not as costly, less than 30 bucks!
http://www.bios-upgrade.co.uk/bios-recovery.htm
http://www.badflash.com/
http://www.recoverybios.com/

Good luck!

HI,
1.Tried the autoexec idea with old bios and success.
2.Retried new bios from screen and again success.
PLease know that you have made a difference
again-thanks - Don